| GENERAL DESCRIPTION |
A self curing two componant Zinc Ethyl-silicate Shop Primer for the protection of steel during fabrication combining with good cutting and welding performance and compatible with wide range of topcoats.
|
| RECOMMENDED USE |
Hydro-electric units, fertilizer, oil refineries,gas plants etc. |
| PRODUCT SPECIFICATION |
| Colour |
Grey |
| Finish |
Matt |
| Mixing Ratio |
1:1/vol |
| Pot Life |
4 hrs |
| Flash Point |
Below 23oC. |
| Solids by Volume |
40% |
| Recommended Dry Film Thickness |
20 Microns |
| Theoretical Spreading Rate |
20 Sq.m/ltr |
| Drying Time- Touch Dry |
15 Min |
| Full cure |
7 Days |
| Recoating Interval (Min.) |
24 Hrs At 30oc and 65% relative humidity |
| Method of Application |
Brush /Airspray / Airless spray |
| Thinner Recommended |
Apiganic Zinc Silicate Thinner 400 |
| Shelf Life |
6 Months At 30oc and 65% relative humidity |
|
| SURFACE PREPARATION |
Sand blasting to Sa 2 ½is must with a profile of 25-50 microns. |
| SUBSEQUENT COAT |
As per recommended coating system |
| REMARKS |
• Apply when humidity is above 50% & temperature in between 0 to 40oC.
• Do not exceed dry film thickness 75 microns to avoid "mud cracking"
• Store in a cool place. Storage life will be reduced above 30oC
• The paint is supplied in two containers BASE& CA. BASE is the binder and CA is Zinc powder. Mix BASE undermechanical stirrer slowly and add Zinc Powder slowly to form a homogenious mixture. Filter through a 80/100 mesh sieve before application.
• 5. Stir well cintinously at the time of painting.
|
| SAFETY PRECAUTIONS |
1.Keep the material away from heat, spark, direct flame.
2.Provide sufficient ventilation when working with solvent
3.based coatings in confined spaces and stagnant air.
Follow local and national Safety rules.
|
